Advice on Death Star Droid

x-wingMark

Jedi Master
Joined
Aug 28, 2013
Messages
833
Location
UK
Hi guys,

Just bought this DSD droid and want to display the usual way but as the bubble is sliced off partly at the bottom the figure falls down. Looking for some ideas and what to do for displaying him.

image.jpeg


1) Does anyone have an old damaged original bubble that I could put over or partly over the bottom to stop him falling out?

2) I could put a bit of cardboard in to stop him falling out but doesn't look great.

image.jpeg


Anyone had this problem in the past with a cut bubble?

Thanks,
Mark
 

SublevelStudios

Sith Lord
Joined
Oct 17, 2013
Messages
2,598
I think using part of another bubble would be better, I'm sure you could find a knackered one that you could salvage. Then just use some small bits of sellotape to attach it to the main bubble. It would look much better IMO.
 

x-wingMark

Jedi Master
Joined
Aug 28, 2013
Messages
833
Location
UK
I think that would be my preference too mate. Just need to keep an eye out for a original bubble I suppose.

Thanks
 

subzero

Sith Lord
Joined
Jun 20, 2017
Messages
3,052
Snaketibe said:
If you put him in a GW acrylic case and stand the figure on another piece of clear perspex, that might work.

You took the words right out of my mouth.

Also as is mentioned a section of old bubble doctored onto it could be a good idea too.
 
Old Thread: Hello . There have been no replies in this thread for 365 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Latest posts

Top Bottom